Roland MP-500 Manuel du propriétaire télécharger pdf (Page 37)

Troubleshooting

If you are encountering problems with the unit, please read the section below before assuming that there is a

malfunction.

The piano cannot be switched on

❍

Is the power cord properly connected? (p. 10)

No sound is produced

❍

Is the [Volume] knob set to the minimum position?

(p. 11)

❍

Are headphones connected? (p. 12)

❍

Is Local On/Off set to “Off”? (p. 32)

Demo songs do not play

❍

Is Panel Lock on? (p. 30)

Metronome does not sound

❍

Is Panel Lock on? (p. 30)

Buttons do not function

❍

Is Panel Lock on? (p. 30)

Keyboard sound does not change

❍

Is Panel Lock on? (p. 30)

Two sounds are produced when the keyboard

is played

❍

Is the keyboard in Dual Play mode? (p. 16)

The pitch of the keyboard sounds incorrect

❍

Is the Master Tuning setting correct? (p. 26)

❍

Is the Key Transpose setting correct? (p. 25)

❍

Is the temperament or the Tuning Curve setting correct?

(p. 28, p. 29)

The pedals are not functioning, or function

intermittently

❍

Are the pedals connected properly?

Make sure the pedal cord is securely connected to the

pedal jack on the back of the unit.

Can’t Record

❍

Is Panel Lock on? (p. 30)

❍

Is the [Demo Song/Key Touch] button’s indicator lit?

Press the [Demo Song/Key Touch] button; the button’s

indicator goes out (p. 13).

❍

The metronome sound or count sound is not recorded.

The recorded performance has been deleted

❍

The performance data that you recorded will disappear

when the power of the MP-500 is turned off (p. 22).

❍

If you record again after recording, the first-recorded

performance will be erased (p. 22).

Sound is distorted

❍

Is the [Volume] knob set to the maximum position? (p. 11)

Bass notes sound wrong/buzzing or vibration

occurs

❍

If you can’t hear the problem in the headphones:

When playing at high volumes, resonance may occur in

the piano itself or in objects near the piano. At times,

other objects in the room, such as fluorescent lights or

glass doors, could start vibrating. Such phenomenon

becomes more prevalent when sounding the lower

frequencies at high volume. To minimize such unwanted

resonance, please observe the following:

- Locate the instrument so it is 10–15 cm away from

walls.

- Reduce the volume.

- Increase the distance from the object that is

resonating.

❍

If you can hear the problem in the headphones:

The problem may be for a different reason. Please

contact your dealer.

In the upper range, the sound changes

abruptly beyond a certain key

❍

On an acoustic piano, notes in the upper one and a half

octaves of the keyboard continue to sound until they

decay naturally, regardless of the damper pedal. There is

a difference in the timbre as well. Roland pianos

faithfully simulate such characteristics of the acoustic

piano. On the MP-500, the range that is unaffected by the

damper pedal will change depending on the Key

Transpose setting.

<When the MP-500 is connected to an

external device>

No sound is produced

❍

Is the power to all equipment turned on?

❍

Are the connections between MP-500 and the MIDI

sequencer or the other external devices correct? (p. 31)

❍

Is the MIDI channel setting correct? (p. 33)

❍

Is the Omni On/Off setting correct? (p. 33)

Strange sounds (or two sounds) are produced

when the MP-500 is played

❍

With the sequencer’s “Thru” function on, the same notes

may be sounded twice. Set the MP-500 to Local off

(p. 32).

The volume level of the instrument connected

to the Input jack is too low.

❍

Could you be using a connection cable that contains a

resistor?

Use a connection cable that does not contain a resistor.

MP-500.e.book 37 ページ２００３年６月１１日　水曜日　午前９時４６分

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Roland MP-500 Manuel du propriétaire Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical supplémentaire Roland MP-500