Roland MV-8800 Manuel du propriétaire Page 67

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 244
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 66
SONG
S-67
MV-8800 Screen Guide
PROJECT SYSTEM DISK/USB MASTERING SAMPLING IMPORT EFFECTS MIXER
SONG
PATTERN INSTRUMENTS AUDIO PHRASES
CREATE CONTINUOUS DATA popup
This allows you to enter automation data that changes smoothly in a specified region (Owner’s Manual;
p. 219).
To access this screen
Accesses the SELECT SEQUENCE EDIT
COMMAND popup (p. 34)
select “Create
Continuous Data...”
[F5](Select)
Explanation of each area
Event
Specifies the type of data that you want to enter.
Range:
Control Change
, Channel Aftertouch,
Poly Aftertouch, Pitch Bend
Number
Specifies the control change number that you want to
enter. This is valid if the Event parameter is set to
Control Change.
Range: 0:BankSel MSB–
7:Volume
–119:
Note
Specifies the note number to enter. This is valid if the
Event parameter is set to Poly Aftertouch.
Range: 0 (C-)–
60 (C 4)
–127 (G 9)
Value From
Specifies the initial value at the starting point of the
continuous data. The range of this value will depend on
your choice of Event parameter.
Value To
Specifies the final value at the ending point of the
continuous data. The range of this value will depend on
your choice of Event parameter.
Curve
Specifies how the value will change from the starting
point to the ending point of the continuous data. The
graph at the right of this parameter will change according
to this setting.
Range: -3, -2, -1,
Linear,
+1, +2, +3
Interval Time
Specifies the interval at which the continuous data will be
spaced. This is specified in units of ticks.
Range: 1 (--) –30 ( )–999 (--)
F-button
[F5](Execute)
Creates the continuous data.
Value
Explanation
Control Change
Channel Aftertouch
Poly Aftertouch
0
–127
Pitch Bend -8192–
0
–8191
Value
Explanation
Control Change
Channel Aftertouch
Poly Aftertouch
0
–127
Pitch Bend -8192–
0
–8191
MV-8800_r_e.book 67 ページ 2006年11月10日 金曜日 午後12時49分
Vue de la page 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 243 244

Commentaires sur ces manuels

Pas de commentaire