Roland TB-303 Manuel d'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 39
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
23
The dual 10 ohm output circuit with the original, large, 1000uf bypass capacitor is
capable of driving headphones hard, including headphones with impedances as low as 8
to 16 ohms. If you want to drive a small loudspeaker, please use a stereo socket and tie
both the ring and the tip of your plug together, with that driving one terminal of the
speaker, with the other terminal going to the ground of the plug.
In general, do not plug a mono 3.5mm plug into this socket, because that will short the
ring connection to ground, causing the Headphone Amplifier to work hard driving its
signal into a 10 ohm load, for no good purpose. If you want to use a 3.5mm mono socket
to get a second audio out from the machine, please plug it in half-way, so the tip of the
plug touches the ring connection of the socket.
Optional Switch for Audio In to Filter
I can install an extra three position toggleswitch, usually located between the Tempo and
Track/Pattern Group Selector knobs, to enable or disable the Audio In to Filter signal,
which is put into the machine via the old Mix In socket on the left of the rear panel.
It has three positions:
Position Audio In to Filter
enabled
Physical switch action.
Up Yes Stays in this position
Middle No Stays in this position
Down Yes Spring return to middle position
Optional Quicksilver 303
I can install the Quicksilver 303 CPU replacement system in a Devil Fish. This replaces
the TB-303’s CPU and provides new sequencing capabilities, with MIDI In and Out via
DIN MIDI connections and via a USB socket. I install a USB isolator for this socket.
If I install this, there can be no 32 Bank Memory system. There is no battery backed up
memory, so there is no need for an internal lithium battery or for installing C-cell
batteries, unless the batteries are needed to run the machine without a power adaptor.
The Quicksilver 303 microcontroller has its own non-volatile memory.
There is a separate manual to describe the particulars of the Devil Fish with the
Quicksilver 303. Please see the page: http://www.firstpr.com.au/rwi/dfish/midi-options/
for further details.
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 38 39

Commentaires sur ces manuels

Pas de commentaire