22
Using M-300 RCS
If you choose S-4000S in the REAC Config dialog box, a 32-in/8-out configuration
will be applied. To change the S-4000S module configuration, proceed as follows.
fig.ScrReacConfS4KS.eps
1
In the REAC Config dialog box, click the “Config” button.
fig.S4KSConf.eps
The “S-4000S Config” dialog box will appear.
2
Use the Slot1–Slot10 pulldown menus to specify the module for
each slot.
The pulldown menu gives you the following choices:
• Blank (empty slot)
• SI-AD4 (4ch Analog In)
• SI-AES4 (4ch Digital In)
• SO-DA4 (4ch Analog Out)
• SO-AES4 (4ch Digital Out)
3
Press the “OK” button to close the S-4000S Config dialog box.
Changing the S-4000S module configuration
If an error is displayed in step 3, one of the following situations may have
occurred. Correct the mistake, and click “OK” once again:
• A module of a differing type is incongruously located between modules; e.g., input
module, output module, input module
• A module of a differing type begins at an even-numbered slot
• Only the odd-numbered slot of adjacent odd-numbered/even-numbered slots is
blank
Commentaires sur ces manuels