Roland SJ-600 Manuel d'utilisateur télécharger pdf (Page 9)

The dialog below is displayed and the Updater Program does not start.

Cause:

The Firmware Updater Program has already been started.

Solution

Quit the Firmware Updater Program.

Can not transfer the firmware with the dialog below

Cause:

There are plural firmware files in the same folder.

Or the firmware file is missing in the folder.

Solution:

Delete the unnecessary files if there are plural firmware files in the folder. There must be only one firmware in the folder.

If the firmware file does not exist in the folder, move it to the folder.

The transfer has been canceled with the message below displaying during transferring.

Cause:

During transferring the firmware, the machine is turned off or the cable is pulled off.

Solution:

Check the Power Cable and connecting status between the computer and printer and then follow the transferring procedure

from the start again.

[Updating the firmware] appears but the status does not proceed and the message below appears after a few seconds or

minutes.

Cause:

The IP addresses set in the printer and the program are different.

The Main Power switch is turned off (switched to [ O ])

The Sub Power switch is turned off (POWER LED is not lit.)

Solution:

Check the IP address on the printer and input it to the Updater Program again.

Turn on the Main Power SW on the printer. (Switch to [ | ] side.)

Turn on the Sub Power SW. (POWER LED is lit.)

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Roland SJ-600 Manuel d'utilisateur Page 9