Roland CDX-1 Manuel d'utilisateur télécharger pdf (Page 15)

Expanding the memory

How to expand the memory

1. Turn off the power to the CDX-1 and any connected equipment, and then

disconnect all cables attached to the CDX-1.

2. Turn the CDX-1 upside-down, and remove the expanding memory cover.

fig.12-02a

fig.12-03

3. Press outward the white clips at either

end of the socket should be in the

downward position.

fig.12-02

4. Paying attention to the location of the

notch on the memory module and the

orientation, insert it vertically within the

guides at either side of the socket.

fig.12-04

5. Move the white clips upward, and press

them until the memory module is locked

in place.

6. Return the CDX-1’s top cover to its original position.

When turning the unit upside-

down, get a bunch of

newspapers or magazines, and

place them under the four

corners or at both ends to

prevent damage to the buttons

and controls. Also, you should

try to orient the unit so no

uttons or controls get

damaged.

screws to be removed (two)

the expanding memory cover

If you have difficulty inserting

the memory module, try tilting

it a bit and inserting one end at

a time.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 251 252

Pas de commentaire

Roland CDX-1 Manuel d'utilisateur Page 15