Roland GK-3B Manuel du propriétaire télécharger pdf (Page 12)

Attaching the GK-3B to the Bass

* Afterwards, you will need to adjust the pickup sensitivity when connecting to GK devices. However, you may find that

the sensitivity level on the GK device is too high. In such instances, you may be able to correct the problem by widening

the clearance between the strings and the pickup. Carry out Steps 1 through 8 again to lower the Pickup height slightly.

■

Attaching the Pickup with Screws

The steps for determining the position for

attaching the pickup and for checking the

height are exactly the same as when using

the double-sided tape. Refer to “Attaching

the Pickup with Double-Sided Tape” (p. 9).

* If mounting the GK-3B with screws, ensure a

minimum string clearance of 15.5 mm (0.6”) from the

body at the position where the pickup is positioned.

Determine the position for attaching

the pickup. When you have determined

the positioning, mark the position of

the holes at each end of the pickup on

the bass’s body.

Remove the strings from the bass.

Using a drill or similar means, open

pilot holes where the attachment

screws are to go in.

* If the pilot holes are not made in the correct

positions, then the pickup will not be attached in the

correct position either. Use extra care when drilling

the pilot holes.

* Make the pilot holes approximately 2 mm (0.08”) in

diameter.

* Drill pilot holes slightly more than 2 mm in diameter if

the bass body is made of a particularly hard material.

Place the springs between the pilot

holes and the pickup as shown in the

figure below, then secure the pickup

with the screws.

fig.1150e

How to Use the Clearance Gauge

The divided pickup height must be adjusted so that the clearance between each string and

the divided pickup is 1.5 mm (0.06”) when the highest fret is fingered.

The clearance gauge supplied with the GK-3B is 1.5 mm thick; place the gauge between the

strings and the divided pickup as shown in the figure below, then check and adjust the height.

fig.1190 (Clearance Gauge)

Wood Screw 3 x 20 mm

Spring

Pilot Hole

GK-3B_e.book 12 ページ２００４年７月２３日　金曜日　午後２時５３分

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Roland GK-3B Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour guitare Roland GK-3B