Roland GK-3B Manuel du propriétaire télécharger pdf (Page 18)

How to Connect the GK-3

* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the

power on all devices before making any connections.

* When connection cables with resistors are used, the volume level of equipment connected to the inputs (Normal

Pickup Input jack) may be low. If this happens, use connection cables that do not contain resistors, such as those

from the Roland PCS series.

* When all devices are properly connected, turn on the power to the various devices in the order specified below.

Turning on devices in the wrong order may result in malfunction and/or damage to speakers and other devices.

Make sure that the power to the GK-

compatible device being connected is

turned off, then connect the device to

the GK-3’s GK connector using the GK

cable.

fig.2010

Connect the GK-3 only with

dedicated GK cable (supplied

with Roland GK-compatible

devices and optional GK cables

sold by Roland). Use of any other

cable may result in damage or

malfunction.

* The GK cable is a locking cable. When disconnecting

the cable, do not pull on it with undue force, but

instead release the lock and gently disconnect the

cable. You can disconnect the cable simply and

easily by holding down the locking portion with

your thumb and gently pulling on the plug.

fig.2020

GK cable

GK-compatible device

GK IN

GK-3_e.book 18 ページ２００６年３月１３日　月曜日　午前９時２５分

1 2 ... 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Roland GK-3B Manuel du propriétaire Page 18