©2007 Roland Corporation U.S. TBS256 www.RolandUS.com
®ÂØÒňÎ
®
FC-300 MIDI Foot Controller
Welcome
Congratulations on your purchase of Roland’s most powerful MIDI foot controller, the
FC-300. This TurboStart contains step-by-step instructions that will quickly introduce you
to the FC-300’s major features.
Changing the Modes
The FC-300 has four modes of operation you can choose from. They are:
Standard Mode
• —This mode is for sending both Control Change messages and
Program Change messages.
Control Change Mode
• —This mode is for sending only Control Change
messages.
System Exclusive Mode
• —This mode is for sending or receiving System Exclusive
messages.
Patch Mode
• —This mode is for sending multiple MIDI messages that have been
previously been saved as patches.
Here’s how to choose the desired mode:
Press the MODE button repeatedly until the mode you want is selected.
1
Tip: To select modes with your feet, simultaneously press the up and down pedals.
Changing the Control Change Numbers Assigned to the Pedals
You can assign any Control Change number (CC#) to a pedal. Here’s how:
Press MODE until the red indicator is lit next to CONTROL.1
Press the PARAMETER 2 button once—“PDL1:Assign CC#65” appears in the
display.
Press VALUE
3 or to change the CC# number. If you’d like to change the
CC# values for the other pedals, repeat Steps 2 and 3.
Once you’ve made all of your desired CC# assignments, press WRITE.
4
Press 5 or to select a memory location (1-5) in which to store your new setup.
Press WRITE twice—the new settings are now stored into the FC-300’s memory.
6
Starting Over
If you’d like to redo the FC-300’s settings from scratch, you can use the following
procedure to clear its internal memory and reload its factory settings.
Caution: All of your stored settings will be lost when you perform a factory reset. Be sure to
back up any information you wish to keep first.
Turn off the FC-300.
1
While holding down 2 and , turn on the power—“Factory Reset Are you sure?”
appears in the display.
Press WRITE.
3
When “Factory Reset Completed!” appears, turn off the FC-300.4
Power-up the FC-300 for use.5
Commentaires sur ces manuels